Purpose
The Team Wendy Exfil Quick Release Adapters allow for tool-free attachment of all Peltor Comtac systems, eliminating the rigid metal headband. Compatible with the Exfile Rail 2.0 Exfil Rail 3.0, Team Wendy SAR Rail and M-216 Rails Systems.
Installing The Boom Mic Adapter
Step 1
Select which mounting post will be replaced by the boom mic adapter post. Rotate the post 90 degrees and firmly pull it off the metal wire (Figure Shown Below)
Step 2
Slide the boom mic adapter post onto the metal wire and rotate 90 degrees to lock it in place. (Figure Shown Below)
Step 3
Attach the Peltor Comtac headset to the boom mic adapter post by aligning the slot on the headset with the post and pressing firmly until it clicks into place.
Step 4
Attaching The 3M Comtac Peltors To The Adapters
Clip the posts onto each side of the 3M Peltor Comtac Communication headset. See Image below. Repeat on the second communications headset earcup.
Attaching The Adapters To The Helmet
Step 1
Identify the W spacer plate on the helmet accessory rail. Use a 1/8' Allen key to remove the two screws that hold it in place. Remove the W spacer plate and accompanying screws from the accessory rail and set them aside for safekeeping. (Displayed Below)
Step 2
With the metal guide wires down in the locked position, insert the tab of the adapter into the T-slot on the helmet accessory rail.
Step 3
Center the adapter over the spacer recess in the helmet accessory rail and press firmly unit you hear and feel a positive click.
Note: Raising the guide wires into the unlocked position allows the operator to swivel the communication cups away from the ears to rest against the side of the helmet when not in use. Snap the guide wire into the locked position for the communication cups to fit closely against the ears.
